The product standard only contains minimum requirements. Attention is drawn to the fact that appliance specifications might contain requirements additional to or deviating from those specified in the relevant product standards.

Please be aware that the specifications nominal value used in the German part of the Schurter catalogue and the data sheets, is synonymous with rated value.

The difference between these two values is a pure matter of definition. In order to avoid any unnecessary complications we will continue to use the specifications nominal value.

CE marking is the only marking which indicates that a product conforms to the relevant EU-directive.

This means that the CE-mark is no quality or standard conformity mark but only an administration mark.

SCHURTER products are covered by the low voltage directives 72/23/EEC and 93/68/EEC. Those are valid for equipment and appliances with rated voltage values between AC 50 V to AC 1000 V as well as DC 75 V to DC 1500 V.

The CE marking of SCHURTER parts will be found on the label of the smallest packing unit. On request we will submitt a CE conformity statement for each component. CE conformity statements and approvals can also be retrieved from the internet under www.schurter.com.

National testing institutions are testing according to national and international standards or other generally recognized rules of technology. Their certification/approval-marks confirm the observance of the safety requirements which electric appliances must fulfil.

Standards IEC 60529; EN 60529 and DIN 40050

Scope

These standards apply to the classification of degrees of protection provided by enclosures for electrical equipment with a rated voltage not exceeding 72.5 kV.

Object

The object of these standards is to give:

a) Definitions for degrees of protection provided by enclosures of electrical equipment as regards:

1. Protection of persons against access to hazardous parts inside the enclosure

2. Protection of the equipment inside the enclosure against ingress of solid foreign objects

3. Protection of the equipment inside the enclosure against harmful effects due to the ingress of water.

b) Designations for these degrees of protection.

c) Requirements for each designation.

d) Tests to be performed to verify that the enclosure meets the requirements of these standards.

Designations

The degree of protection provided by an enclosure is indicated by the IP code.

Elements of the IP code and their meanings

A brief description of the IP code elements is given in the following table.

1. Protection against direct and indirect contact – general terms

The protection against electric shock on electric equipment as well as their components are divided into the following parts:

¹⁾ Accessible, conductive part, which is not conductive normally but which may be conductive due to a failure.

2. Protection against direct contact with live parts e.g. of a fuseholder

The data sheets of the relevant components inform about the taken measures.

3. Protection against indirect contact

Measures for the protection against indirect contact on electrical equipment are defined according to IEC 61140 by the 4 protection classes 0, I, II, III. Each protection class includes two protection measures. Even if one of these measures should fail, no electric shocks will occur.